sebotron wrote: ↑Wed Sep 15, 2021 9:31 pm
Quick question, should the middle pin be connected to the ground pins of the FXCore or to its RST pin?
Ground on your PCB which should be same as FXCore ground.
sebotron wrote: ↑Wed Sep 15, 2021 9:31 pm
My understanding is that the chip has to be powered on its own, ie the ICP board does not provide power so I'm assuming that the middle pin serves to pull down RST during programming in the same fashion as the FT260's RESETN pin on the dev board. Just want to make sure!
ICP does not supply power, it is strictly for talking to FXCore.
It does not reset the FXCore, ground is strictly a reference for the signals.
The FT260 RESETN does not reset the FXCore, it is just using the same reset signal as FXCore. It is an input to the FT260.
FXCore is not reset (externally) for programming. When FXCore sees the command sequence to enter programming mode it stops executing and waits on programming instructions, once all the programming is done and it sees the exit command it does a "soft" internal reset. Basically is acts like a program change so it clears delay RAM, loads the program to execute, etc.